Aluminum rod

Aluminum bar alloys include 6061, 7075, 2A12, 2A14, 2A50, 2017, 2024, 3A21, 3003, 5052, 5083, 5A02, 5A05, 6063, 6082, 7A09, 7050, etc

6061aluminum rod
Status: T6, t651, h112, o
Round bar: Φ 3mm~500mm
Square bar: 3~200mm high; Width 20~500mm
Hexagonal bar: s=6~50mm (opposite side)
Product uses: Aerospace fixture, electrical fixture, communication field, and also widely used in automatic mechanical parts, precision machining, mold manufacturing, electronics and precision instruments, SMT, PC board solder carrier, etc.
Introduction: 6061 aluminum bar is a heat treatable alloy with good formability, weldability and machinability. At the same time, it has medium strength and can still maintain good operability after annealing. The main alloying elements of 6061 alloy are magnesium and silicon, forming Mg2Si phase< br> T651 is the main state of 6061 alloy. It is a high-quality aluminum alloy product produced by heat treatment and pre stretching process. Although its strength cannot be compared with 2XXX series or 7xxx series, it has many magnesium and silicon alloy characteristics, such as excellent processing performance, excellent welding characteristics, electroplating, good corrosion resistance, high toughness, no deformation after processing, dense material without defects and easy polishing, easy coloring film, excellent oxidation effect, etc.

7075aluminum rod
Status: T6, t651, t7351, t7651, o
Round bar: Φ 4mm-400mm
Square stick: according to customer requirements
Hexagonal bar: according to customer requirements
Main uses: in the field of aviation and aerospace, molds, golf heads, tooling fixtures, mechanical equipment< br> Introduction: 7075 is a cold treated forging alloy with high strength, far better than mild steel. 7075 is one of the most powerful alloys in commerce. General corrosion resistance, good mechanical properties and anodic reaction. Fine grains make the deep drilling performance better, the wear resistance of tools is enhanced, and the thread rolling is more distinctive. 7075 aluminum is called ultra-high strength aluminum alloy. The yield strength of the alloy is close to the tensile strength, the yield ratio is high, and the specific strength is also very high, but the plasticity and high temperature strength are low. It is suitable to be used as load-bearing structural parts at room temperature and below 120 ℃. The alloy is easy to process, with good corrosion resistance and high toughness. High strength heat treatable alloy. Good mechanical properties. Good usability. Easy to process, good wear resistance. Good corrosion resistance and oxidation resistance.